How can we help?

Follow

Pairing Your Devices (After Initial Red Tabs have been pulled)

You will need to put the SmartBase into pairing mode before pairing devices.

Verify the SmartBase is in pairing mode and is blinking green. If not, press the dark gray button on the bottom of SmartBase and hold until it starts blinking green.

Keypad: If the keypad does not blink green, insert the included SIM popper or a small paper clip into the hole just above the “Pairing” label on the back of the Keypad. Hold for two seconds and release to start the pairing process again.

Water leak/temp: If the sensor does not blink green, push and release the circular button located on the bottom of the sensor. The sensor should blink green after a few seconds. 

Motion Sensor: If the sensor does not blink green, insert a paper clip into the hole labeled “Pairing” on the back of the sensor near the battery door. Press and hold this button for 2 seconds.

Entry Sensor: If the sensor does not blink green, push the round test button on the front of the sensor for 2 seconds and then release. The sensor will start blinking green indicating that it is ready to connect to the SmartBase.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments