browse

Verify the SmartBase is in pairing mode and is blinking green. If not, press the dark gray button on the bottom of SmartBase and hold until it starts blinking green.

 

Keypad: If the keypad does not blink green, insert the included SIM popper or a small paper clip into the hole just above the “Pairing” label on the back of the Keypad. Hold for two seconds and release to start the pairing process again.

Water leak/temp: If the sensor does not blink green, push to the circular button located on the bottom of the sensor until it starts blinking green

Motion Sensor: If the sensor does not blink green, insert a paper clip into the hole labeled “Pairing” on the back of the sensor near the battery door. Press and hold this button for 2 seconds.

Entry Sensor: If the sensor does not blink green, push the round test button on the front of the sensor for 2 seconds and then release. The sensor will start blinking green indicating that it is ready to connect to the SmartBase.

1500003693762

Articles in this section